Valor Fires 842 Istruzioni per gli Interventi Scaricare il pdf (Pagina 8)

The Innova front is designed to be used on the

Dimension heater when mounted to the wall

either fully recessed or partially recessed.

Note: When mounting to decorative surfaces such as wall paper, care

should be taken not to drag the heater down the wall as this may damage

the decorative surface.

Fully Recessed Installation

Make the cavity into the wall.

Place the heater in the cavity. Ensure the heater is true and square when aligning

to cavity.

Drill the wall if necessary at the four xing points—see gure 5.

Secure the heater with screws.

Partially Recessed Installation using the Spacer Frame

The Innova front is supplied with a separate spacer frame for use in installations

where the space in the wall is not deep enough to take the full depth of the heater. The

minimum depth required is 3-1/2” (9 cm).

For your safety, the frame and heater must be securely xed to the wall.

The rear of the spacer has two screw location slots in the top ange. These should be

to the rear when tting.

Make the cavity into the wall.

Position the spacer frame against the wall. Ensure that the

spacer frame is central to the wall opening.

The top rear ange of the spacer frame has two xing

points—see gure 6. Drill the wall at the two xing points.

Secure the spacer frame to the heater using four no. 8 x

3/8 screws supplied—see gure 7.

Align the heater with spacer attached to the two drilled

xing points and secure to the wall with two

screws.

Front Installation

Remove the front from its packaging.

There are two magnets on the lower rear of the

front. They should rest against the outer edge

of the two raised sections. Ensure that they are

located correctly before tting the front.

Hold the front rmly and lift into place. Keeping

the magnets away from the body of the heater,

locate the front hanging brackets into those on

top of the heater—see gure 8. Lower the front

into place and swing the bottom of the front

towards the heater to engage the magnets.

Installation—Innova

Figure 5

Figure 6

Figure 7

Screw xing points

22-1/2”

(57 cm)

15-1/2”

(39 cm)

3-1/2” (9 cm)

partially recessed

6-1/2” (17 cm)

fully recessed

8-1/2” (22 cm)

from floor surface

recommended

Cavity minimum dimensions

Figure 8

Magnet

locations

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commenti su questo manuale

Nessun commento

Valor Fires 842 Istruzioni per gli Interventi Pagina 8

Commenti su questo manuale

Prodotti e manuali riguardandi Stufette Valor Fires 842